![]() For example: typing $112=600 changes the z max rate to 600. To change a setting, type the identifier of the parameter (for example $100 for x steps) "=" and then the new value. Steps/mm needs to be calculated and the easiest way of doing it is by using prusas reprap calulator. The most important part to change is the steps/mm. Type "$$" and a list of commands should appear, like this: You should see a message like this "Grbl x.xj " if you dont see the message, make sure that your are connected to the correct port and use the baudrate of 115200. ![]() ![]() To communicate with your board you need to open the arduino ide serial monitor. Now with firmware on your board you need to adapt grbl to your specific machine.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |